Non-Slip Mono Knot
Non-Slip Mono Knot
A simple and very strong non-slip loop knot. Creates a fixed loop at the end of the line that allows lures, jigs, and flies to move freely — with nearly 100% breaking strength.
Video by Sportfishing Report on YouTube
About the Non-Slip Mono Knot
The Non-Slip Mono Knot (also called the Homer Rhode Loop Knot) creates a fixed non-slip loop at the end of the line that tests at or near 100% breaking strength — making it the strongest loop knot available. The free-swinging loop gives lures, jigs, and flies maximum movement.
Unlike the Rapala Knot, the Non-Slip Mono Knot doesn't require threading through the overhand knot twice, making it slightly faster to tie with practice. It's the preferred loop knot of many offshore anglers for jigs and pitch baits.
Best Used For
Ideal applications
- ✓ Jigs and soft plastic baits
- ✓ Hard baits where free movement improves action
- ✓ Fly fishing for large fish
- ✓ Any loop knot application requiring maximum strength
Not ideal for
- ✗ Braided line (slips)
- ✗ Situations where a fixed connection is needed
Step-by-Step Instructions
Follow these 5 steps to tie the Non-Slip Mono Knot. Watch the video above while following along.
Step 1: Tie a loose overhand knot
Tie a loose overhand knot in the line about 10 inches from the end. Leave it very loose.
Step 2: Thread through the hook eye
Pass the tag end through the hook or lure eye, then back through the overhand knot from the same direction it entered.
Step 3: Wrap 4-6 times
Wrap the tag end around the standing line 4-6 times above the overhand knot, moving away from the lure.
Step 4: Pass back through the overhand
Thread the tag end back through the overhand knot from the lure side going toward the wraps.
Step 5: Wet and tighten
Wet generously. Pull the standing line to slide the overhand knot toward the lure eye while maintaining the loop. Pull all parts firmly to lock the knot. Trim the tag end close.
Pro Tips
- Four wraps for 20+ lb, 6 wraps for lighter line
- The overhand knot must stay loose until the final tightening
- Loop size is determined before final tightening
- Pull hard — this knot needs significant force to fully lock
Common Mistakes
- Tightening the overhand knot too early
- Wrong direction threading back through the overhand knot
- Not enough wraps for the line weight
- Closing the loop accidentally before tightening